What is the minimum order for a private-label programme?
One piece for an evaluation unit, and 100 pieces for the first private-label run. Below 100 pieces the unit ships in a neutral carton carrying no factory branding; your enclosure print, model code and manual start at the 100-piece run.
How long does the first private-label article take?
Lead time is 10 days for 1 to 5,000 pieces once the artwork and parameter set are approved. A first article adds one sample cycle on top of that, because the print and the parameter file are proofed before the run starts.
Whose name is on the product, the carton and the manual?
Yours. The programme covers the enclosure print, the nameplate and model code, the carton, the insert and the manual. Nothing on the housing points back to the factory unless you keep the factory mark for warranty routing. Tooling, firmware and artwork stay yours under NDA.
What documents do I get for vendor onboarding?
CE attestation of conformity for the Low Voltage and Electromagnetic Compatibility directives, issued by UDEM, and the ISO 9001 certificate 78623Q0124R0S issued by STC (华标认证) to GB/T 19001-2016 / ISO 9001:2015, whose certified scope is the research and development service of industrial variable frequency controllers. Each unit ships with a test sheet carrying its serial, and the serial-to-carton mapping is retained for warranty traceability.
Can I have exclusivity for my territory?
Exclusivity is offered against an agreed annual volume and is written into the partner agreement, not published as a public policy. Territory, the models reserved to you, and the annual price band are the three things settled in that document. Ask for the partner terms and they come back with the quotation.
Once I am a partner, will you sell the same model into my territory?
Where exclusivity is granted, the reserved model code is not sold into that territory for the term of the agreement — not to a competitor, not into a tender, and not from our own desk. A reserved code is also not listed on our storefront and not quoted to the accounts you have registered with us. That boundary is written into the territory clause; the volume and the term are set per partner, because both depend on the market you hold.
Who handles after-sales, and who owns the end customer?
You do. End-customer contact stays with the partner, and warranty runs 12 months from the factory. A board swap can be recovered with one keypress because the parameter file is held on board, so a service call does not depend on a laptop and a file from us.
What can be changed on the drive itself?
The electrical build (voltage re-rating, reactor and filter population, conformal coating, braking unit), the firmware and parameter set (duty macros for solar pumping, pressure PID, brake logic), and the identity layer (print, nameplate, carton, manual). Modbus RTU is standard; EtherCAT, PROFINET and CANopen are quoted on request.
What is not published on this page?
Discount bands, exclusivity thresholds and stock commitments. They depend on territory and volume, so they are agreed in writing rather than posted as a list that would be wrong for most partners.