Six loads, one platform decision.
The drive is chosen from the load profile, not the motor nameplate. Below is the matching rule used on this site and the parameter that matters in each case.

Irrigation & Solar Pumping
MPPT tracking, dry-run protection, 220 V or 380 V input
How this duty is drivenMunicipal & Surface Pumping
PID pressure loop, multi-pump staging, soft start ramp
How this duty is drivenHVAC & AHU
Energy-optimised fan curves, 0.5–16 kHz carrier for low noise
How this duty is drivenBlowers & Compressors
Torque boost at low frequency, over-excitation braking
How this duty is drivenConveyors & Handling
S-curve acceleration, DC braking without a resistor option
How this duty is drivenMachine Tools & OEM
RS485 Modbus RTU, parameter set pre-loaded to your machine
How this duty is driven
Conveyor · pump · fan · HVAC — one parameter platform, four duty profiles
How the match is made
Variable-torque loads — centrifugal pumps and fans — take a frame at motor rating because torque falls with the square of speed. Constant-torque loads — conveyors, spindles, compressors — need one frame up when the start is loaded or the ramp is short.